034510.jpg

Description

Purpose:
The center connectors connect both milled bars with the drilled one in one stable crossbar.

Material:
PA, non-mixed material of prime quality only

Fogging test 1279-4:
by MPA Darmstadt

Protection by patent:
Design protected by CERA property rights.

Storage:
All CERA products have to be stored in original packaging, kept dry and protected from UV radiation. Storage temperature must not be less than +10° C.

Storage life/durability:
CERA products have no expiration date, if properly stored.

Handling:
To form the crossbar, you need two center connectors and one steel pin. This fits for all 18, 26 and 45 sizes of center connectors. At first the steel pin should be put into the first center connector, then the open end of the pin should be pushed into 3.5 mm drill hole of the drilled bar. Then the second connector should be put over the steel pin till the steel pin is centered between the connectors. The four grid lugs guarantee the anti-rotation of the crossbar. Then both milled bars should be put over the center connectors up to the stop.

Processing instructions:
The CERA items stated below are only to be installed in the same spacer width as shown in the line of the size measurement table. After assembly, thermal endurance up to +110° C is possible, but only if no additional load occurs.

Environmental sustainability:
safe to use and represents no health hazard, completely recycable

Specifications

Material PA
Profile type Aluminium
L - H 4510
System Solutions Center Connector
System properties Assembly with steel pin
Color grey
SZR 15161820
Back to: Muntin Bar 76