04032.1.jpg

Description

Purpose:
Sleeve for bended spacer bars when gas is injected manually with a gas probe.

Material:
PA, non-mixed material of prime quality only

Fogging test 1279-4:
by MPA Darmstadt

Protection by patent:
Design protected by CERA property rights.

Storage:
All CERA products have to be stored in original packaging, kept dry and protected from UV radiation. Storage temperature must not be less than +10° C.

Storage life/durability:
CERA products have no expiration date, if properly stored.

Handling:
Depending on the product code used, a specified hole diameter is to be drilled vertically through spacer. The hole needs to be clean and free from swarf. The sleeve can then be pushed snugly into place from the reverse side (sealing face) of the spacer bar.

Processing instructions:
The CERA items stated below are only to be installed in the same profile drill hole as shown in the line of the size measurement table. After assembly, thermal endurance up to +110° C is possible, but only if no additional load occurs.

Environmental sustainability:
safe to use and represents no health hazard, completely recycable

Specifications

Material PA
Profile type WarmEdge
Bore ⌀ 4,0 mm
System Solutions Gas fitting
System properties Sleeve
Color grey
SZR 810
Profile height 7,0 mm
Back to: THERMIX TX PRO